A series of pictures below showing the recent steps in finishing the body panels ready for painting. I made a mistake at the front with the holes for the overriders, even after measuring three times I forgot I was only marking an initial point and not the real point where the holes were needed. Ah well some fibreglass and filler - no one will know.

The doors are proving to be a pain! If any one's fitted a cupboard door you'll know how hard it can be to get it lined up, imagine a door that is curved in several directions!!

One door is now in place with hinges and opener, it's a bit out of alignment which will have to be dealt with before Friday. The other is already in a better position so should end up being easier to get right.

Some more holes to drill for the roll bar and top seat belt anchor points then we can think about what else might be needed before painting. It's going to be a busy week.