I had to go and get some more bits today whilst waiting for some other parts from Dax. I was 'told' to replace this nice shiny glass fuel filter with a cheap plastic affair because these can break apparently and that's not good!



I also had to route the fuel line over the chassis which required some copper fuel pipe, a few bends and connectors.

With a bit of luck the heater elbows will arrive soon along with the missing front over rider. Everything that needs to be done before the engine goes (back) in is now ready to do!

I also bought some liquid rubber to cover the under side of the front and rear wings this will give some protection against stone chips from underneath.